Standard Horizon GX1250S User Manual

GX1250SHorizon Eclipse+25 watt VHF/FMMarine TransceiverOwner’s ManualStandardCommunications

Owner's ManualGX1250SPage 84 INSTALLATION4.1 FREQUENCY AND DEVIATION TESTSFCC regulations require that the transceiver’s deviation and frequencyb

Owner's ManualGX1250S Page 9Figure 3. General InstallationFigure 4. Regular Mounting BracketFigure 5. CMB16 Mounting BracketSPEAKER(OPTIONAL)BATT

Owner's ManualGX1250SPage 104.3 INSTALLATION USING REGULAR MOUNTINGBRACKET1. Mount the bracket using the washers, nuts, and long hex head bolts.2

5 OPERATIONAfter the transceiver has been installed (see section 4), ensure thepower supply and antenna are properly connected.5.1 RECEPTION1. Turn th

Owner's ManualGX1250SPage 123. Press the PTT (push - to - talk) switch. The TX indicator in the LCD isdisplayed.4. Speak slowly and clearly into

5.6 SCANNING1. Adjust the SQUELCH CONTROL until the background noisedisappears.2. Select the desired channel to be scanned using the UP or DN key.3. H

5. Even when the transceiver stops and listens to the signal of amemorized channel, the transceiver will DUAL WATCH between thischannel and the priori

5.9 EMERGENCY CHANNEL 161. To select the emergency channel, press the 16/9 key from anychannel.2. Transmit your emergency signal in the same manner a

Owner's ManualGX1250SPage 166 MAINTENANCEFor preventive maintenance and instructions on obtaining factory service,please refer to the OWNER’S MAN

7 SPECIFICATIONSPerformance specifications are nominal, unless otherwise indicated, andare subject to change without notice.7.1 GENERALFrequency Range

TABLE OF CONTENTSGENERAL INFORMATION ...1INTRODUCTION...

StandardCommunicationsStandard Communication Corp.P.O. Box 92151Los Angeles, CA 90009-2151Telephone 310/532-5300© STANDARD COMMUNICATIONS CORP. 1998Al

1 GENERAL INFORMATION1.1 INTRODUCTIONThe Standard Communications Corp. (SCC) GX1250S Eclipse+ is a VHFtransceiver designed for use in the frequency ra

Additional FCC and DOC data, including licensing requirements,are contained in the companion document titled OWNER’SMANUAL SUPPLEMENT. The document al

3 CONTROLS AND INDICATORSRefer to Figure 1 for the location of the following controls, indicators, andconnections:3.1 CONTROLS AND CONNECTIONSqqPOWER

Owner's ManualGX1250SPage 4Horizon ECLIPSE +UPH / L SCANDN WX16 / 9R/DSQLVOLU I C • • DNUPqqwweerrttyyuuiioo!!00Figure 1. Controls and Connec

SCAN KEYStarts and stops scanning programmed channels. Holding down thiskey, scanning channels are programmed.16/9 KEYImmediately recalls channel 16 f

!!11UP KEYSelects the desired channel. Each press increases the channelnumber. When held down the channel numbers increasecontinuously.!!22DOWN KEYSel

TX IndicatorTransmission indicator. The TX indicator appears when th PTT switchis pressed and it is O.K. to transmit.MEM IndicatorIndicates the channe