Standard-horizon CP500 User Manual download pdf (Page 44)

Page 46 CP500

5. Move the ShuttlePoint knob to highlight EDIT and press [ENT] to change the Icon field.

6. Move the ShuttlePoint knob to highlight the desired Icon and press [ENT].

7. Move the ShuttlePoint knob to the right to select the Mark name field. Press [ENT] and

the first digit in the name will be highlighted.

8. Move the ShuttlePoint knob up or down to select the first character.

9. Move the ShuttlePoint knob to the right to select the next character.

10. Repeat steps 8 and 9 until the Mark name is shown. Press [ENT].

11. Move the ShuttlePoint knob to the right to select the Lat/Lon field and press [ENT].

12. Move the ShuttlePoint knob up or down to select the first character.

13. Move the ShuttlePoint knob to the right to select the next character.

14. Repeat steps 12 and 13 until the desired position is shown.

15. Move the ShuttlePoint knob to the right to select the Mode field and press [ENT].

16. Move the ShuttlePoint knob up or down to select the mode to show the Mark. You can

choose among SHOW to show on the chart the name and icon of Mark, ICON to show

on the chart only the icon of Mark or HIDE to hide on the Chart page the created Mark.

Press [ENT].

17. Press [CLR] and a WARNING “Save the new Mark?” popup window will be shown.

Move the ShuttlePoint knob to the right or left to select

YES or NO and press [ENT].

18. Press [CLR] and the new Mark appear on the Chart page.

NOTE

After entering in all the Marks it is a good practice to back up the points to a C-MAP User C-CARD.

Refer to Section 11.

7.4 GOTO CURSOR

The GPS Chart Plotter allows you to quickly start navigating to the Cursor, Route or Mark.

GOTO CURSOR

1. Move the ShuttlePoint knob to the exact position you want to navigate to.

2. Press [GOTO] and a GOTO popup window will be shown

Figure 7.4 - GO TO menu

3. Move the ShuttlePoint knob to highlight CURSOR and press [ENT].

4. The GPS Chart Plotter is now navigating from your current position to the location

selected at step 1.

Figure 7.4a - Navigating to Cursor Example

5. Now the GPS Chart Plotter shows a bearing line between the vessels location and the

1 2 ... 39 40 41 42 43 44 45 46 47 48 49 ... 88 89

No comments

Standard-horizon CP500 User Manual Page 44