Standard Horizon CP150C User Manual download pdf (Page 30)

Page 32 GPS Chart 150C

3.7.0.4 Locating a Mark

To select User Points List page follow the procedure (a) or (b):

a. Press “MENU”, select USER POINTS LIST and press “ENTER”.

b. Move the cursor over a Mark. A pop up information window will be shown.

Press “ENTER” and select DIRECTORY from the pop up information

window and press “ENTER”.

The User Points List will be shown. Using the ShuttlePoint knob up or down to select

the Mark you want to locate on the Chart page. Move the ShuttlePoint knob left or right

to select LOCATE and press “ENTER”. The Chart page will be shown with the cursor

on the top of the Mark you located.

3.8 CREATING AND USING ROUTES

To create a Route:

a. Move the cursor to a position that you want to place the starting point of the

Route and press “ROUTE”. This places a Waypoint on the chart. A pop up

window will appear showing information related to the Waypoint.

b. To change the name of the Route press “ENTER”, select EDIT, press

“ENTER” again and edit the name using the ShuttlePoint knob.

c. To place the first leg of the Route, move ShuttlePoint knob to the position

of the first leg and press “ROUTE”.

d. Repeat these steps until all the legs of the Route are shown on the Chart

page.

Figure 3.8 - Route planning

3.8.0 Creating a new Route

To create a new Route press “MENU" and select ROUTE + SELECT and press

“ENTER”. Move the Shuttlepoint knob to select an open Route position (example

Route 2) and press “ENTER”. Repeat the steps in 3.8 to create a new Route.

3.8.1 Deleting a Waypoint

Place cursor on Waypoint:

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 71 72

No comments

Standard Horizon CP150C User Manual Page 30