Standard Horizon CP150C User Manual download pdf (Page 50)

Page 52 GPS Chart 150C

SLAVE

Press the “MENU” + ADVANCE SETUP + “ENTER” + INPUT OUTPUT + “ENTER”

+ INTERNAL GPS SETUP + “ENTER” + OPERATING MODE + “ENTER”+ SLAVE

+ “ENTER”

TRANSFERING USER POINTS:

STANDARD HORIZON Chart Plotters can transfer User Points between plotters:

User Point List Send/Receive

To use this function the Blue wire of the Master must be connected to the Brown wire

of the Slave.

Sending User Points from Master to Slave:

1.On the Slave: Press “MENU” + USER POINTS LIST + “ENTER”+ RECEIVE +

“ENTER”. This enables the receive mode on the Slave. The Slave will listen 2 minutes

for the user points to be sent from the Master.

2.On the Master: Press “MENU” + USER POINTS LIST + “ENTER”+ SEND +

“ENTER”.

Sending User points from Slave to Master:

1.On the Master: Press “MENU” + USER POINTS LIST + “ENTER”+ RECEIVE +

“ENTER”. This enables the receive mode on the Slave. The Slave will listen 2 minutes

for the user points to be sent from the Master.

2.On the Slave: Press “MENU” + USER POINTS LIST + “ENTER” + SEND +

“ENTER”.

NOTE

When sending or receiving user points the autopilot NMEA output and the receiving

of GPS Satellite signal is disabled.

3.15 TERMS AND FUNCTIONS

3.15.0User Points Handling functions

User Points are geo-referenced objects that can be placed on the Chart page by the

user. Typical User Points are Marks and Waypoints. User Points have selectable

shape, label and color.

Example of typical User Point shapes:

Figure 3.15.0 - User Points icons

User Point colors is to be chosen amongst the colors not already used to fill the charts

(Depth areas, Attention area, in order to make User Points better visible when placed

on the charts).

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 71 72

No comments

Standard Horizon CP150C User Manual Page 50