Standard-horizon HX-471S User Manual download pdf (Page 24)

HX471SPage 22

6. BASIC OPERATION

6.1 INITIAL SETUP

1. Install the belt clip on the transceiver according to the description in the

box below, if desired.

2. Install the nylon carrying strap on the belt clip, if desired.

3. Install the battery pack on the transceiver (see section 4.1.3 “BATTERY

INSTALLATION/REMOVAL”).

NOTE: Water resistance of the transceiver is assured only when the

battery pack is attached to the transceiver and MIC/SP rubber cap is

installed in the MIC/SP jack.

How to use the Quick Draw Belt Clip

1. Connect the hanger to the rear of the HX471S, with the notch

pointing directly up, using the supplied screw (Figure 1).

Use only the screw included with the clip to mount the clip to

the back of the transceiver!

2. Clip the Quick Draw Belt Clip to your belt (Figure 2).

3. To install the HX471S into the Quick Draw Belt Clip, align the

hanger with the Quick Draw Belt Clip and slide the HX471S into

its slot until a click is heard.

4. To remove the HX471S from the Quick Draw Belt Clip, rotate the

HX471S 180 degrees, then slide

the transceiver out from the Quick

Draw Belt Clip (Figure 3).

Figure 3Figure 1 Figure 2

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 60 61

No comments

Standard-horizon HX-471S User Manual Page 24